Product Data Sheet Show all documents
Davco® 4 in 1 Grout Additive

Davco® 4 in 1 Grout Additive

  • Concentrated grout additive designed to increase the flexibility, strength and water resistance of cement based grouts.
  • Davco® 4 in 1 Grout Additive is suitable for interior and exterior domestic applications. Ideal for submerged and high foot traffic areas, where a high degree of deformability is required.

  • Increases flexibility, strength and water resistance of cement based grout
  • Enhances the colour of grout 
  • Reduced likelihood of efflorescence
Product Data Sheet Show all documents

Usage

  • To reduce the porosity of cement based grouts
  • To improve the compressive strength of cement based grouts
  • To improve the flexural strength of cement-based grouts
  • Suitable for use when grouting over fibre cement sheet floors and swimming pools or where a greater performance level / heavy duty performance is required
 

Advantages

  • Increases flexibility, strength and water resistance of cement based grout
  • Enhances the colour of grout 
  • Reduced likelihood of efflorescence

Packaging

Available in a 1Ltr r 5Ltr Jerry can

Colour

White liquid, dries clear.

Product Details

Product Information

Shelf life

If unopened 12 months from date of manufacture.

Storage conditions

Store off ground in dry cool conditions out of direct sunlight.

Specific gravity

1.0kg/L

Flash point

Non Flammable

Volatile organic compound (VOC) content

Low VOC - Specification for V2 IEQ-13, V1.1 IEQ-11

 

Application

Consumption

Recommended dosage

Davco 4 in 1 Grout Additive must be diluted with clean, potable water at a ratio of 1:1 for use as an additive in cement based grouts. Thoroughly mix the required amount of 4 in 1 Grout Additive and water together as per the following:

Grout

Davco 4 in 1 additive

Water

Davco Elite G10 Grout 1kg

125ml

125ml

Davco Superfine White Grout 1kg125ml125ml

Davco Sanitized Colorgrout 1kg

125ml

125ml

Davco Slate n Quarry Grout 1Kg

100ml

100ml
Application steps

MIXING

GROUT MIX PROCESS

  1. Add the required amount of Davco® 4 in 1 Grout Additive and water mixture into a clean bucket.
  2. Slowly add the powder to the liquid while mixing by hand or with a mixing paddle attached to a drill.
  3. Continue to mix for several minutes until a toothpaste-like consistency is achieved, free of lumps of powder.
  4. Allow mixture to stand for 5 minutes, remix then use the grout.
  • Do not add any additional water during the potlife of the grout, restir only without adding water.
 

APPLICATION

  • The grout should be applied as per the instructions for the grout, including joint shaping and clean up, refer to the relevant product datasheet for the grout.
  • Once the grout has sufficiently hardened, the tiles should be polished with a dry cloth. Ensure the face of the tiles are cleaned and polished within 4-6 hours
  • For difficult to remove areas, it is recommended to use Davco Sanitized® Tile and Grout Cleaner

CLEANING OF TOOLS

  • Clean tools and equipment with water before the grout dries.

Documents