Product Data Sheet Show all documents
SikaBond®-205 Brushable Contact Adhesive

SikaBond®-205 Brushable Contact Adhesive

Quick bond contact adhesive

SikaBond®-205 Brushable Contact Adhesive is a premium neoprene brush/roller grade contact adhesive.

  • One-component adhesive
  • Very short flash-off time
  • High initial tack
  • Brush or roller apply
  • High heat resistance
  • Broad adhesion range
  • Quick tack
Product Data Sheet Show all documents

Usage

SikaBond®-205 Brushable Contact Adhesive for fixing vinyl skirting and other common flooring materials where a quick contact bond is required to plaster, timber and metal substrates.  

Advantages

  • One-component adhesive
  • Very short flash-off time
  • High initial tack
  • Brush or roller apply
  • High heat resistance
  • Broad adhesion range
  • Quick tack

Packaging

4 litre & 20 litre Pail

Colour

Light yellow

Product Details

Product Information

Composition

1-component Neoprene

Shelf life

SikaBond®-205 Brushable Contact Adhesive has a shelf life of 12 months from the date of production, if it is stored properly in undamaged, original, sealed packaging, and if the storage conditions are met.

Storage conditions

SikaBond®-205 Brushable Contact Adhesive shall be stored in dry conditions, protected from direct sunlight and at temperatures between +5 °C and +25 °C.

Density

~0.85 kg/litre

Solid content by mass

~20%

Consistency

Thixotropic liquid

Application

Application Information

Ambient air temperature

 +15 °C to +30 °C

Substrate temperature

 +15 °C to +30 °C

Open Time

~20 – 40 minutes at 50% RH / 21 °C

Curing rate

~24 hours
Consumption

Consumption

~3 - 4m2 per litre
Application steps

SUBSTRATE PREPARATION

To obtain the best results, the materials to be bonded should be dry, clean, and free from dust, grit, oil, grease and other contaminants that may affect final bond.

 

CLEANING OF EQUIPMENT

Clean tools immediately after use with Sika® Remover-208. Dried adhesive may be softened using a Sika® Remover-208. Once cured, the material can only be removed mechanically.

IMPORTANT: Do not use solvent cleaner directly on finished floorcovering, as the solvent cleaner can potentially cause damage to the surface.

Documents