Sikafloor®-264 T AU

12 months

Store away from direct sunlight and idealy between +5 to 35 Degrees C

Part A  - 1.41kg/litre   Part B -  1.00kg/litre   Pigment  - 1.75kg/litre  Resin mixed - 1.33kg/litre     all density values at +23 degrees C

Conforms to Aust.Standard test ASTM D3960.

Greenstar Building Council of Australia  -   Green Star Office Design V2 IEQ-13  / Green Star Office Interiors V1.1  IEQ-11

76    (7 days / +23 degrees C)

70mg (CS10/1000/1000)  (8 days / +23 Degrees C)    DIN. 53 109 Taber Abrader test

Low sheen to Semi gloss  (depending on temperature at application)

Sikafloor®-264 T AU has excellent resistance to a wide range of chemicals.  Refer to Sika Technical for specific information on resistance to chemicals.

Approx. total system DFT    0.6- 0.7mm  (Depending on substrate density and profile)

+10 degreesC min. / +30 degreesC max.

80% r.h max.

Beware of condensation       The subsrate and uncured floor must be at least 3 degrees C above dew point to reduce the risk of condensation or blooming of the surface finish.

+10 degrees min.  /  +30 degrees min.

Approx. values   +10 degrees C approx 25 min.   +20 degrees C 15 min.  +30 degrees C 8 min

Intercoat times between system layers

Substrate Temperature            Minimum             Maximum          

       +10 degrees C                      24 hours                 4 days

       +20 degrees C                      12 hours                 2 days

       +30 degrees C                        6 hours                 1 day

  Temperature       Foot traffic     Light traffic     Full cure   

  +10 degrees C       72 hours            6 days           10 days

  +20 degrees C       24 hours            4 days             7 days

  +30 degrees C       18 hours            2 days             5 days

Note: These are approximates and will be affected by changing ambient conditions

Levelling :  Rough surface profiles may need to be levelled first to ensure a high quality even finish. Sikafloor 160 combined with silica fillers. The grade and filler content can be altered to accommodate the depth of profile to be filled. Refer to Sikafloor 160 TDS for guideance.

Mixing:  Add pigment pack to the part A and mix to blend in.  Add the Part B and mix the full kit for a minimum of 2 minutes.

Application:

Apply product using a medium to long knap roller (15-20mm) with a central pole double frame arrangement.  Apply evenly at the prescribed coverage rate then "lay off " in the opposite direction of rolling for optimum results. Final layoff technique - take the weight of the roller and lift the roller from the surface when completing to lay off stroke.   Not adopting the technique and or not having sufficient manpower to execute this proceedure will likely result in uneven appearance.

Sikafloor®-264 T AU must be thorougly mixed using a low speed stirrer (300 - 400 rpm)

Placing the kits at an even rate of pot life and joining up wet edges progressively within even time frames is critical for optimum results.  If this is not adhered to then differing colour shades will result when the product has reached touch dry stage.

Clean all tools immediately after use Thinner C. Hardened and/or cured material can only be removed mechanically.

Sikafloor®-264 T AU should be kept as clean as possible to maximise durability and reduce abrasion.  Good housekeeping practices should be followed when Chemical spills occur.  Clean with neutral based, non solvent based cleaning chemicals. - Refer to Sikafloor Cleaning Guidelines document for more details.