Sikafloor®-94
Low viscosity, solvent free epoxy Primer and general purpose Binder resin
Sikafloor®-94 is a two component, low viscosity, 100% Solid Epoxy Primer and Binder resin system
- Low viscosity
- Excellent substrate penetration
- Very low odour - VOC
- Excellent binder for mortars
- Fast to cure
- Can be accelerated with Sikafloor Booster
- Economical
- Good Chemical Resistance
Usage
- Primer for concrete surfaces with Sikafloor resin systems.
- Binder resin for Epoxy mortar Sub-fill mortar screeds.
- Binder for epoxy Coving mixes.
- Flow and scratch coat layering prior to Sikafloor systems.
Advantages
- Low viscosity
- Excellent substrate penetration
- Very low odour - VOC
- Excellent binder for mortars
- Fast to cure
- Can be accelerated with Sikafloor Booster
- Economical
- Good Chemical Resistance
Packaging
Available in proportioned 30 kg, 60 litres and Bulk 200 kg Parts A+B
Colour
Yellowish transparent
Product Details
APPROVALS / CERTIFICATES
Potable Water certified to AS 4020 - 2014
VOC compliance to Aust. Green Building Codes V1.1-13.1.1 and V1.1-12.1.1B
Shelf life
Stored in original sealed containers within the temperature range of +5 to +35 degress C, this product will keep for 3 years from date of manufactre.
Storage conditions
Stored in a dry place and out of direct sunlight within temperatures as mentioned above.
Density
1.1kg / litre
Compressive strength
> 40 MPa
Tensile strength in flexure
22 MPa
Tensile adhesion strength
12 MPa approx - (to sandblasted steel)
Application
Mixing ratio
Part A Part B = 2 :1 (by Mass and Volume)
Ambient air temperature
Application range recommended +5 to +30 Degrees C
Pot Life
10 Degrees C - 30 mins.
20 Degrees C - 20 mins.
Waiting time to overcoating
10 degrees C 15 hours
20 degrees C 8 hours
Note: Waiting times are approximately halved with the addition of Sikafloor Booster
Consumption
Primer
CSP 2-3 profile 5-6m2 L approx.
CSP 4-5 profile 2-3m2 L approx.
Mortar
Range of 1:5 to 1:8 mixed litre of Sikafloor®-94 to kg blended silica sands
MIXING
Part A and B to be mixed the correct ratio for a minimum of 2 minutes
APPLICATION
Primer
Roll product evenly on and into the surface.
If the product is completely absorbed then an additional coat should be applied within 24 hours.
Mortar
When used as a binder in Profiling screeds or Coving mixes, the substrate should also be primed with Sikafloor®-94