Davco® Superfine White Grout

Plastic film bags: if unopened grout shall remain usable for up to 18 months from date of manufacture.

Paper bags: if unopened grout shall remain usable for up to 12 months from date of manufacture.

Store grout in an elevated location, in dry cool conditions out of direct sunlight.

AS ISO 13007.3 CG1

1.3kg/L

Low VOC - 3g/L (SCAQMD method 304-91)

5.5 - 6 Litres per 20kg bag

40 Minutes at 23°C and 50% RH.

24 hours at 23°C & 50% RH.

Quantity of grout required kg/m²

The coverage of the grout will vary depending upon the texture, size and thickness of the tile and the width of the grout joint. Use the table as a general guide only.

Tools required;

• Mixing buckets & clean water
• Drill with mixing paddle
• Grout float / rubber squeegee
• Sponge & dry cloth
• Personal protective equipment

• Before commencing grouting, ensure the tile adhesive has set firmly. This usually requires 24 hours with the majority of tile adhesives depend on application conditions.
• Remove any spacer lugs, rake-out any excess adhesive and any loose or foreign material from the grout joints.
• In general, ensure the grout joints are clean and dry.

1. The mixing ratio is 20kg of powder to 5.5-6L of potable water.
2. Add the water to a bucket, then slowly add the Davco Sanitized® Superfine White Grout powder to the water. Stir the mix until a lump-free toothpaste consistency is achieved.
3. Allow the mix to stand for 5 minutes, re-stir, then use the grout.

• Note: Where movement is expected, or for superior performance in general applications, use Davco 4 in 1 Grout Additive instead of water alone. Refer to the Davco 4 in 1 additive data sheet for additional information.

1. Prior to grouting it is advisable to lightly dampen the grout joints, particularly with porous tiles or in hot conditions.
2. Using a rubber float or squeegee, work the grout into the joints in a diagonal motion. Make sure the grout is worked into the joint (it should not bridge the joint).
3. Using a diagonal motion remove excess grout from the surface of the tiles with a rubber float or squeegee.
4. Clean up the remainder of the grout with a lightly dampened sponge. Regularly rinse the sponge out to help with cleaning and don’t make it too wet.
5. Leave the grout to cure for 24 hours before cleaning the haze off with a dry cloth. 

Tools and surrounding areas should be cleaned up with water while grout is still soft and wet

Davco® Superfine White Grout shall require routine maintenance and cleaning with a neutral detergent and water.