Sikafloor®-08 Primer

Green Star VOC-SCQMD Rule 1168

Acrylic liquid

12 months from date of production (in closed packaging)

Store in a cool, dry place. Do not store below +5 °C. Material that has been
mixed with water should be used within a week.

When Sikafloor® or Lanko® self-levelling products are applied

Note: Mix ratio & application device recommendations should be followed
depending on the type of surface mentioned above.
Not following these recommendations may result in poor performance and
possible product/system failure.

Between+5 °C to 35 °C

▪ Internal or external porous concrete
▪ Internal cement levelling compound
▪ Internal Sikafloor®-4020 FiberLevel levelling compound
▪ Internal timber/wood/cement sheeting/wall lining

Before applying Sikafloor® or Lanko® products.

Note: All values are approximate and subject to climatic conditions.

•  1:3 dilution ~ 6-9 m2 per mixed L
•  Neat ~ 5-6 m2 per L

Average consumption is dependent on absorbency of the substrate,

applicator device and mixing ratio.

Suitable mixing buckets, clean cool water, mixing drill
& paddle.

Soft bristle broom or 12+mm napped paint roller.

▪ APPLY DILUTED
Sikafloor®-08 Primer by way of a soft bristle
broom, or 12+mm napped roller. Correct amount

of mixed primer liquid should always be applied to

the prepared substrate, giving good penetration

and film build. Thin applications may result in

pinholing in the finished surface or debonding
levelling compound from the substrate.
On particularly porous surfaces where the initial prime
coat is absorbed immediately, or mechanically
prepared surfaces a second coat is recommended.
Avoid foam during application by adding more liquid.
▪ APPLY NEAT
Sikafloor®-08 Primer over raw timber/chipboard,
cement sheeting or Sikafloor®-4020 FiberLevel with a

long napped roller 12mm+.
Note:
For best practice it is recommended subsequent
construction materials are applied as soon as primer is
dry, but no later than 24hrs.
▪ Care must be taken not to allow dust to settle on the
freshly primed surface.
▪ If dust has contaminated the surface, first
vacuum clean and apply another coat of primer before
subsequent materials are installed.

▪ Do not allow primer to pool while drying as
this will cause a soft spot under construction material.