Davco® Rejuvenation Grout

12 Months from date of manufacture if unopened

Store in dry cool conditions, off ground out of direct sunlight

Low VOC - 2g/L (SCAQMD method 304-91)

All measurements are taken at 22ºC and 50% relative humidity. Specifications vary according to site conditions and should be taken as a guide only.

1.7kg pail of Davco Rejuvenation Grout covers approximately 20m2 (based on 200 x 200mm tiles with a 4mm wide by 1mm deep grout joint)

• Protective personal equipment
• Grout float or squeegee
• Grouting sponge
• Bucket and clean water

• All surfaces must be installed according to manufacturer’s instructions and relevant Australian Standard(s) and be structurally sound, dry, clean and free from movement, oil, grease, wax, sealers, curing compounds, release agents and any other loose or contaminating material
• The tile and grout surface must be thoroughly cleaned with either a mild soap and water mixture or sugar soap mixture. If required, a bristle brush can be used to clean the existing grout joints

• Rinse surface with clean water to ensure there is no residue on the surface and allow the surface to completely dry prior to application of Rejuvenation Grout

Stir thoroughly before use

1. Apply to the grout joint and using the float or squeegee, spread diagonally across the joint. Ensure you are filling the joint evenly. Only cover 1m² at a time as Rejuvenation Grout will be difficult to clean off once it dries.
2.  After approximately 5-10 minutes, clean off excess grout and evenly shape the grout joints by laying a damp sponge on the tile surface and lightly wiping in a circular motion.
3. Finish the application with a single diagonal wipe to the tile surface with a well wrung sponge. Avoid applying excessive force or repeatedly wiping as this may remove the grout from the joint. If the water in the bucket becomes dirty, replace with clean water. 

Tools and equipment can be cleaned with water prior to the grout drying.