
Eco Systems Progrip Paste
A premixed thin bed flexible wall tile adhesive for ceramic tiles designed for most typical construction boards including cement sheet, & plasterboard.
- Premixed, ready to use
- No wasteage
- Flexible
- Good hanging
- Water washable
- Easy to trowel
Usage
Eco Systems Progrip Paste is designed for fixing porous backed ceramic tiles internally over; Porous cement boards / sheeting Plasterboard Suitable tile types include, Porous back tiles Mosaics Over sika approved tile-able waterproof membranes* *Tiles must have a minium pososity of >5% and maximum tile size 600x300 / 450x450Advantages
- Premixed, ready to use
- No wasteage
- Flexible
- Good hanging
- Water washable
- Easy to trowel
Packaging
15Ltr Pails / 48 per pallet
Colour
White paste
Product Details
Shelf life
12 months from date of manufacture
Storage conditions
Store in dry cool conditions out of direct sunlight.
Product Declaration
D1TE Class adhesive AS ISO 13007:2013
Application
Ambient Air Temperature
+5°C Min to +35°C Max
Substrate Temperature
+5°C Min to +35° Max
Open Time
30 Minutes at 23°C & 50% RH.
Adjustability Time
Up to 45 minutes dependent on tile and substrate porosity.
Applied Product Ready for Use
USE | WAIT TIME |
Grouting | 24 hours |
Full use / return to service | 5 days |
Values determined at laboratory conditions: 23° & 50% RH.
Higher temperatures will reduce times and lower temperatures will increase times.
Tile and substrate porosity will impact adhesive drying times.
Consumption
Notched Trowel Size | Approx cobverage per 15Ltr |
4mm Notched Trowel | 12m2 |
8mm Notched Trowel | 7-8m2 |
APPLICATION
Tiles shall be fixed in accordance with AS3958.1-2007.
Ensure the backs of tiles are free from dust and contaminates.
Appliy th paste adhesive to the substrate with the appropriate sized trowel to acheive coverage requirements on both substrate and the back of the tile. Tiles may require "back-buttering" to acheive minimum coverage requirements.
Apply the adhesive with the notched trowel in a single direction. While pressing the tile into the wet adhesive break the ridges with the tile to fully bed the tile into the adhesive.
It is advisable to periodically check the backs of the tiles to ensure minimum adhesive coverage requirements are being acheived.
Only apply enough adhesive that can be covered prior to the adhesive skinning. If skinning occurs remove and replace with fresh adhesive.
Remove any excess adhesives from the face and joints with a damp sponge while the adhesive is still wet. Ensure grout joint are of uniform depth.
Expansion and control joints must be installed as per AS ISO 3958.1-2007.
CLEANING OF EQUIPMENT
Tools and equipment can be cleaned with water while the adhesive is still wet.